Blade Scanning System
Where blade heights are larger, as in large scale industrial power turbines, a greater scan range is typically required.
Replacing the small pneumatic actuator with a specialised Rotadata probe traversing actuator provides the increased range of movement required.
A fixed mirror probe similar to, but longer than, that of the pneumatic system, is mounted in the actuator.
The Rotadata probe traversing actuators have proven their reliability with over 30 years of service with many major engine manufacturers.
The actuator can traverse the probe to view any blade height within its range.
Probes can be interchanged to provide a variety of scanning capabilities. The probe is driven to a set of pre-defined blade heights. At each
scan position, a set of data is collected over a number of engine revolutions.
Platform Scanning System
In addition to measuring temperatures on the surface of the blade airfoil, the blade platform temperature profile can be of interest. A much
steeper viewing angle is required to measure the blade platform, this is typically achieved by replacing the mirror in the end of the probe with a prism.
The probe is mounted in a specialised Rotadata probe traversing actuator with both linear and rotary drives to provide the necessary positioning
Probes can be interchanged to provide a variety of scanning capabilities. By changing between prism and mirror probes, the dual axis actuator can
be used to perform platform or blade scanning as required.
The viewing angle is determined by the prism angle and the probe is inserted into the gas stream to a pre-defined depth to perform the scan. The probe
is then rotated through a set of angles corresponding to positions along the platform. At each position, a set of data is collected over a number of
engine revolutions. Probe rotation combined with blade movement gives the scan area.
The Rotadata Electro-Mechanical System includes:
- Preliminary evaluation stage to determine optimal solution
- 3D heat mapping, gas flow analysis and heat transfer analysis
- Probe design to meet environmental requirements
- Probe calibration
- Supply of calibration equipment, training and tools
- Design and supply of engine interface parts
- System hardware production and supply
- Supply of system software for actuator control and data acquisition and processing
- Training in system use at Rotadata or on customer site
- Support during system installation
- Support during engine testing